You can multi-select Boxes or tasks using CTRL+left click (or CMD on Mac). Once selected, the list of tasks will be highlighted in blue. You can, for example, drag-and-drop them in-between other tasks to move the list.
Alternatively, you can move the tasks using the arrows found on the module's header.
A notification will be displayed if the operation was partially successful or unsuccessful.
Multi-select is supported by the following modules:
Overview
Gantt
Scope
Board
Available actions
The list of all available actions is presented in the table below:
Action
Description
To select multiple tasks (selected tasks are highlighted in blue), use:
cmd or ctrl + left mouse button
select tasks one by one
shift + left mouse button
select a range of tasks
To unselect use:
ESC
unselect all selected tasks
click out of the zone
unselect all selected tasks
cmd or ctrl + left mouse button
unselecting tasks one by one
Possible actions
Depending on the type of tasks selected, you will be able to perform the different operations listed below:
parent task with all its children:
move up/down,
indent, outdent,
delete,
color change,
parent task with selected children or without children:
delete,
color change,
all children from a single parent, not including the parent task:
outdent,
delete,
color change,
selected children from one parent, not including the parent task:
move up/down,
indent, outdent,
delete
color change,
multiple children from different parent tasks, not including the parent tasks:
